Subject: aluminum tube bending
From: Paul
Date: 7/13/2000, 8:04 PM


"Terry S. Wilson" wrote:

  A machinist I worked with once, had to fabricate a decreasing  radius
continuous
bend of several revolutions of tubing. He very cleverly, I thought, made
a mandrel
on the lathe and (this may apply here) filled the tubing with cerro
bend,(pardon my
spelling). After the process was completed  he went over to the Insta-hot
at the
sink and melted the filler out.



Excellent idea, we use it when machining honeycomb.  Unfortunately a
3 ft long 1.25 ID tube would take a LOT of cerrosafe which is pretty
darned expensive.  For those who don't know, cerrosafe is a brand name
of a set of bismuth alloys which melt below the boiling pt of water.
I use it for casting rifle chambers.  Neat stuff. Probably too expensive to
use for us, but perhaps a shop might have it and to the tube.

There are also shops with NC tube benders, I imagine that the
uniqueness of each installtion would make programming & setup
prohibitive.

Bill

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org