Subject: Bending aluminum tube-2nd try
From: Paul
Date: 7/14/2000, 10:35 PM

Kent White wrote:

Ok,
Have you tried filling the tube with serrobend and then using a bender to swing it 90deg?
Kent

On Thu, 13 Jul 2000 23:24:25 -0700, Paul wrote:

Kent White wrote:

....And the bend radius???
1 inch/
2 inch?
Or an easy 12 inch?
Kent

Opps sorry Kent forgot about that. I would say for intake pipes we need about
3 inches center to center with a 1.75 inch OD tube 180 degrees.

For 1-3/8 OD water plumbing four inches center to center 90 degrees should be fine.

Paul Lamar


On Thu, 13 Jul 2000 20:08:40 -0700, Paul wrote:

Kent White wrote:

Jim Brewer has asked me "how to bend aluminum tube", and asked for my reply to this address.
Let us begin by defining the field.
What is the temper, alloy and thickness of this aluminum?
What is the O.D.?
What radius are we bending to?
There are many approaches to "bending aluminum tube", but it is best
to thin out the potential failures with
a little reasoning before committing serious time and effort.
Once we limit the field, then we may ask which methods have
failed so far, narrowing our choices a bit  more.
Kent

Kent White
http://www.tinmantech.com
TM Technologies, Tools and Methods for better Metalwork

      "Kent White" <kent@tinmantech.com>

Kent we need 1-3/8 OD .049 wall 6061.

Kent White wrote:

Ok,
Have you tried filling the tube with serrobend and then using a bender to swing it 90deg?
Kent

Yes. It has been suggested Kent. I personally have not done it yet.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org