Mount the rad at an angle to keep the aircraft frontal area
down. Angle mounted rads work very well as this induces turbulence
inside the core improving heat transfer as the air is forced
to change direction upon entering the core.
Paul Lamar
George Lendich wrote:
Paul,
Just trying to come to grips with what I have read around the traps
and what you are saying here.
>From what I read in aircraft use, one needs to have high pressure
and low air speed (in the cowl) for max heat transfer, as it goes
through the rad.
I believe you are saying that you are getting this from thinner rads
(where some go thicker ie 2.5") and reduce the air speed going
through the rad by creating turbulence withhin the rad by placing
it at an angle to air flow.
Am I reading you correctly Paul. If this is correct, it clarifies things
for me. I have been somewhat confused on the matter as I felt one
had to set the the rad/fins directly opposite air flow for best
air flow/performance.
George (down under)
This is somewhat a relatively new idea. Back in World War II all rads
where installed in the aircraft perpendicular to the air stream.
For example the rads in a P51 were over 11 inches thick. that included
intercoolers and oil coolers as well as water. The P51 had a 1400
HP and the slip stream was something to behold so it got away
with this for takeoff and a fast climb out.
Now a days if you look in a combination air conditioner and furnace
the HP and air pressure provided by the fan is modest so thinner
heat exchangers are used with more area but of the same volume.
they are mounted in the AC unit in a V shape. The same principle
is applied in modern cars. The rads are getting wider, taller and
thinner. This make them more efficient for slow speeds while climbing
hills and for low power electric fans.
In our case we want the engine to cool while climbing out at
80 or 100 MPH. Dynamic pressure is used to force air through the
rad and is proportional to .0026 X MPH^2 in pounds per square foot.
So the most efficient rad to use is a large area thin rad. If we
mount it perpendicular to the air stream it would add way too
much frontal area and drag to the airplane. We could do it like
they did in WW I and put a hole in the center for the prop shaft :-)
The best way is mount it almost horizontal underneath the engine
and let the air turn to go through it and again coming out the
back side of the rad. The inlet duct must be properly shaped
for uniform flow through the rad or most of the air will try
to get through the back end of the rad.
The outlet duct must be unrestricted and straight for half a foot
or so. This means it is best to take air in below the rad and
let it out the top into the cowl. The sides of the cowl become
the best places to put the exhaust pipes and cowl flaps.
This also has the advantage in that the air intake is about as far
from the prop center as possible so the slip stream velocity is
at maximum for cooling on the ground and during climb.
BTW it took us a couple of years on this news letter to figure all this
out :-)
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org