Subject: Teflon encapsulated silicone O-rings
From: Paul
Date: 7/16/2000, 6:44 PM

I just got the teflon encapsulated O-rings. They look real good
except the one for the outer oil control ring was too large
in cross section so it will not fit properly. Too hard to 
assemble and I think the outer oil seal ring will not move in 
an out freely if you force it in. I will try to exchanged 
them this week for smaller section O-rings so that will delay 
the delivery of the first two sets.

I am real excited about these O-rings as they will add a margin
of safety to the engine. You should be able to over heat the
oil to 240 degrees F or so without destroying these O-rings.
I would not run my oil at that temp but it could happen.

BTW don't ever try installing the oil seal rings with the O-rings
in them without the springs. The oil rings will sink down too far 
in the rotor grooves and be nearly impossible to get them out without 
breaking the oil control rings first. In that case your expensive 
teflon encapsulated silicone O-ring will be damaged. I just learned this 
lesson the hard way.
  

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org