Subject: Thermostat or no thermostat & cooling
From: Paul
Date: 7/16/2000, 5:57 PM

tommayer wrote:

Paul, at risk of showing my stupidity--I probably did something wrong--there
is another way and another consideration.  When I turboed my Lyc in my
Mustang I HAD to have big inlets.  I'd often come out of Mazatlan with the
OAT 100 or higher and go to FL 210 at 150 hp all the way up.

    Sometimes the temp at altitude would be minus 25 F, and not much above 0
F on the ground in Chihuahua when I got there, so I had lots of shock
cooling worries, in addition to wanting to go faster in cruise.

    I have at least 7500 hours in various piston engine airplanes with cowl
flaps, so naturally I rigged a cowl flap on the Mustang.  There were two
problems, one of which I found insurmountable.

    When I made a cowl flap big enough to do the job, and tried to operate
it with a very expensive vernier cable, on the second flight coming downhill
at 210 mph IAS the pressure stripped the vernier, the flap went to trail,
and I had big problems keeping the jugs green.  I fixed that with some bell
cranks and a few weeks of weight training to get my arm strong enough to
work the apparatus.

    The other problem was that closing the cowl flap SLOWED THE AIRPLANE
DOWN by 5 to 7 mph IAS, as opposed to leaving the cowl flap in trail.  I
verified this on at least a dozen flights, both by IAS indications and very
careful 4 way runs with GPS.

    Closing the cowl flaps caused a great deal of nose down pitch and
necessitated a great deal of nose up trim.

    The only explanation that came to my uneducated mind was that air under
pressure has weight, and closing the cowl flap effectively added significant
weight to the nose of a plane with a downdraft cooling system.  (You are
likely choking with laughter by now.)

I think you changed the angle of the drag vector on the airplane.

    But I know the airplane went slower with a cowl flap arrangment big
enough to handle the various conditions I regularly encounter.

Got any pictures of the inlets?

   The fix was install a couple of sliding inlet doors, which were very
simple to fabricate, very light, and which operate very easily at any speed
and can be powered by a cheap choke cable.  I now have over 500 hours
experience with them.  Closing them in cruise boosts speed by 3 mph max.
However, I never see a cyl temp above 400 on climb, or one below 300 on
descent, even from the flight levels in winter in turbulence when I have to
reduce power and ATC wants a rapid descent.  In cruise the split from
hottest to coldest cyl is around 20 F.  I can move the doors separately.  By
diddling and fiddling in cruise I can get the split even less, with all four
jugs within ten degrees of 375 F, which is what Lycoming says is optimum.

    I decided the Russians had gotten it right.
    Probably none of this is applicable to a radiator installation on a
rotary, but I pass it on in case it might be. Tom Mayer


Interesting stuff Tom. Thanks. I think you might be right about the
Russians. Sibera is real cold I under stand.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org