Subject: Bending aluminum tube-2nd try
From: Paul
Date: 7/17/2000, 8:19 PM



Kent White wrote:
....And the bend radius???
1 inch/
2 inch?
Or an easy 12 inch?
Kent

Opps sorry Kent forgot about that. I would say for intake pipes we need about
3 inches center to center with a 1.75 inch OD tube 180 degrees.
For 1-3/8 OD water plumbing four inches center to center 90 degrees should be fine.

Paul Lamar


Kent White wrote:
Ok,
Have you tried filling the tube with serrobend and then using a 
bender to swing it 90deg?
Kent

Yes. It has been suggested Kent. I personally have not done it yet.

Paul Lamar


Kent White wrote:

Paul,
The remaining bit of info not supplied so far is Temper of the .049 6061 Aluminum tube.
This means how hard the metal is, added to the strength 
from alloy (aluminum, 6061) and thickness (.049).
Although perhaps trivial and possibly of minor consequence to the bystander, 
It matters a great deal to the
guy making the part. This is why  Alloy, Temper, and Thickness are specified, 
along with the diameter of
said tube and the bend radius. The latter probably matter more to 
some than the former, but it is nice to
have all pertinent details so to make a nice part.
Please send temper, as in "0", or T3 or T6.
Thanks,
Kent White
www.tinmantech.com
TM Technologies
Tools and Methods for Better Metalwork


We know how to normalize the 6061 T6 to T0 with a torch but if 
T6 can be bent more power to us.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org