My homemade water pump has a 4 inch impeller and 1 1/8 id in and
out. But I
have got to check it at 6500 RPM before I dare put it on the engine. BIG
pulley on the driving motor! I don't know if I have a motor big
enough to
drive it at that speed.
Bob Darrah
Mark Steitle wrote:
Reply to: RE: Tracy's well pump.
Bob,
I have a 5 hp, 110v tablesaw motor that you can use. You have my number.
Mark
Bob how high is the pump inlet from the water supply?
Please raise the pump in six inch increments and report the change in flow
at a give RPM. I am curious what this factor has to do with our
installations as invariably the pump inlet is above the rad.
Paul Lamar
Jeff Spitzer wrote:
Pump height is irrelevant in a closed system.
Jeff Spitzer
Yes. It is true that in theory it is always "under water"
but there are small pressure changes never the less.
I would still like to see the rate of change in an open
loop system. In Bob's test case it is not a closed loop system.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org