Hi, Mark....
push down all the way on the gas pedal, and crank for 5
secs then let go. It will start if it hasn't sit for 2 long. <<
That was my first thought, the first couple times it happened, but it
didn't seem to help...I'm assuming that the rotors can stop in just about
any position inside the housings, and when the sticking apex seal stops
at the point where it's compressed, then sticks, it has no compression
until it unsticks and can again follow the surface.
I expect that it frees up pretty quickly, as the compression comes back
after a few seconds of cranking, but it apparently can't fire the now oil
rich mixture until the gas can wash some of it out....
I will have the oil metering pump disconnected now, so if it does stick
again, I at least won't have all that oil smoke to deal with. I'll keep
everyone informed if it happens again, and what, if anything, is
different.
1. Clean and replace the injectors<<
Why clean them if I'm going to replace them? <G>
Or do you mean clean OR replace them! ;-)
That's something I should probably check. I got the car from my sister,
and she had it regularly serviced by the Mazda dealer.....I've only put
about 10,000 miles on it since then, so I would assume that the injectors
have been checked....but it won't hurt to check them again.
3. Remove spark plugs and put a teaspoon of auto tranny fluid in there
to
build up compression if it has sat for a long time.<<
This never seemed to happen after it had been sitting for a couple of
weeks. It happened the first time over at my son's apartment...I had
only been there about an hour and when I went out to drive back home no
compression. That has happened at least twice since then...within an
hour of running it...and all the other times (maybe 6 ) it happened
within 24 hours of running the car.
In fact I remember that once I had compression for appx. one revolution,
then lost it.....which is what makes me think it's an apex seal.
AS I told Paul, I have the time to play around with it...so I'll make
these incremental changes and see how it effects the problem. If the
problem has been solved, it could take as long as a month to find out for
sure...short of taking the engine apart, that is, and I'm not quite ready
to do that yet.
Thanks for the info..
Harley
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org