Kinsler wrote:

Paul,

Butterflies would be $14.35/Each
The throttle shafts would be $48.20/Each

I do not understand what you mean by bearings to fit our arms?

Thanks,

Tom

I am sorry Tom. Correction: Bearings to fit your shafts. 

We will machine the throttle body housings to our design and use your shafts,
bearings and butterflies. If you don't have shaft bearings what material would 
you recommend for shaft bearings? I would expect that aluminum bearings would 
wear eventually.

Paul Lamar

-----Original Message-----
From: Paul <rotaryeng@earthlink.net>
To: Kinsler <kinsler@tir.com>
Date: Saturday, July 08, 2000 12:01 PM
Subject: Re: Kinsler Request

I need some two inch butterflies with shafts and bearings to fit your
arms.

Thanks.

Paul Lamar

Kinsler wrote:

Paul,

We can make just about anything in the way of shafts and butterflies.  We
have bronze bushings and air horns.

Please let me know what sizes you need and dimensions for the throttle
shaft.

Thanks,

Tom

-----Original Message-----
From: rotaryeng@earthlink.net <rotaryeng@earthlink.net>
To: tom@kinsler.com <tom@kinsler.com>
Date: Thursday, July 06, 2000 10:50 PM
Subject: Kinsler Request

Below is the result of your feedback form.  It was submitted by
(rotaryeng@earthlink.net) on Thursday, July 6, 2000 at 23:50:02

name: Paul Lamar

comments: Hi Guys. I am designing an EFI
peripheral port, wrap over the top manifold
for a 13B rotary. The runners are 24 inches
long for good torque at 6000 RPM. Injectors
out near the ends.

I need two shafts, bronse bearings, air horns
and two throttle plates about two inches in diameter.

Got anything like that?

I have your catalog already.

I will be using your throttle arms and
linkages.

Paul Lamar