Perry Mick wrote:
Paul:
Here are the drawings for the left and right side
brackets to use the stock 13B mounting points.
I just dimensioned it to the nearest .05 inch, so
users of these drawings may want to measure the
engine with metric tools to get better accuracy
for the hole placements. Assumption is 3/16
steel for both parts.
The right side part mounts under the oil pan,
and picks up three oil pan bolts. You will have
to grind off the 1/8" flange on the oil pan outer
edge so this bracket can be flush against the bottom.
--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com
You might need one or more one inch high ribs under that
right side bracket. 3/16 is a bit thin to load in bending.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org