Al Gietzen wrote:
norm doty wrote:
actually these low melting point alloys are not that expensive, take a
look
at small parts, they have it in stock.
the first alloy is pretty steep, but the rest are reasonable.
What is (who is) 'small parts'; are where are they. I'd like to get some of
the serrabend (sp?) or comparable.
Anybody know where I can get 1 7/8 dia, 2.5" CLR, schedule 16, 90 degree
bends?
Al Gietzen
FAX this guy a drawing Al. He is in Lancaster.
Aero Bending Co. FAX (661) 948 5548
Phone 661 948 2363
43328 Division St.
Lancaster CA 93535
Not on the Internet.
He claims he can spin a bell mouth on the intake end of the tube as well.
Lets us know how it works out.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org