Subject: Abel Ibarra's 750 HP 13B
From: Paul
Date: 7/23/2000, 9:04 PM


<< Here is a picture of Able Ibarra's 750 HP 13B side port. >>

In what trim did the 13B develop 750 HP. I could use a bit of that...

Lynn E Hanover

Well I will have to dig back through all the old messages but I think it
was 45 psi boost, alcohol and nitrous oxide. It was a TO4 turbo and Abel launched
at 10K and shifted at 8K I think. If memory serves me right it was 
175 MPH in less than 8 seconds with a 2000 pound stock steel body
Mazda R100. Abel, I think was the first guy to discover
that rotaries and high boost go together like cream and strawberries.

Mazda predicted this in a 1984 SAE paper. Not that I am recommending
this HP level in an aircraft as that would be silly unless one were
racing at Reno. It just shows to go you however just how robust a 13B engine
is. Unlike piston engines catastrophic failures like the engine blowing 
up as in hand grenades are almost unknown in a rotary.

I think he uses Hurley Engineering 3 mm two piece apex seals.

Here is a picture of Abel's sewer pipe sized intake plumbing.
That is some serious air going through there.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org