Subject: New six port intake manifold flanges.
From: Paul
Date: 7/23/2000, 9:27 AM

Scott Gettings wrote:

These look great.  With all the difficulty with obtaining tight 180 degree
tubing bends, is there any validity to welding  a short 90 degree tubing with
small flanges onto your flanges (to get to a horizontal flange position).
These could then be bolted to another set of 90 degree tubes of lighter
material, such as composite, to form the rest of the dynamic chamber and
throttle body connection?  This is similar to the original intake manifolds
which come up 90 degrees to the horizontal, but of course have a bunch of
extra weight and attachments that are not needed. I suppose another
difficulty with a composite dynamic chamber would be the ports for the fuel
rail.

Comments?

Scott Gettings


I would think that would work. The aluminum ports for the injectors should be
no problem in a composite intake  manifold if they are machined with some 
grooves on the out side to lock them into the epoxy fiberglass runners.
I can do a limited amount of that kind of stuff on my lathe if you send
it to me. I think Kinsler has injector welding adapters that could
be grooved on the outside and bonded in.

BTW the composite intake runners could be attached with short hoses and hose
clamps once you weld short straight pipes onto the flange. In a NA engine
you usually have some vacuum to hold them on so you could probably get
away with no hose barb beads. I would not try that with a turbo engine however.
The short straight pipes would be real cheap and all bends could be 
done in the composite part. Build up a bunch of layers to make it
strong as back fires have been known to blow them apart.

The composite intake manifold looks like the lowest cost way to go.
It would be nice if someone made molds for wax cores complete
with bends and bell mouths. Bulk wax can be bought in hardware
stores as it is used for home canning. A large ball mill in 
a two inch thick aluminum block will work. Come to think of 
it I know just the guy to make these molds as he has a really 
large mill. Another way of doing it is saw apart a pre bent tube.  

Another thing I would like to get around to some day is finding how how to
expand styrofoam beads in a mold using steam. Coffee cups are made that way.
That would be super useful for all sorts of things as entire Saturn engines 
are cast using styrofoam cores. We would also need to search for a source
for the styrofoam beads. Anybody want to take on this project? Howard?

The cores would be tough, cheap and easy to ship. Someone could make some money
making and selling these intake manifold styrofoam cores.

BTW I checked the flanges against my 1988 six port 13B and they fit fine.
Mike Wills did a good job on the drawing.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org