Mike Pienaar wrote:
Paul
I have finally "bitten the bullet" and decided to go the rotary route. Contrary to
expectation I managed to find a Mazda rotary turbo with intercooler very similar to
the pair featured in the e-mail "Two engines for sale. Maybe" dated 7/7/2000 from
Carlos Noto. The engine has the same "auto TX flexplates" as in the picture.
I would like to send you a few pictures to make sure I have done the right thing.
How do I reduce the size of the files and how do I check what size the file is?
Using Windows 95/98 you go into Windows Explorer and enable "Details"
under "View". That puts the file size up in K keep it under 150K to 200K and I
will handle it from there. If you are scanning a 5 by 7 inch photo use 150
pixels per inch. I can probably determine the year of the engine if you
take a good picture of the turbo side. If you are using a digital camera
use the 640 by 480 option.
Which manuals do you recommend? I know this has been covered before but I cannot
find the e-mail anymore,
The Haynes manual is about your only choice. What year is your engine?
The Mazda shop manuals are very nice if you can find them but they run
$100 US in the States. Bruce's video is excellent.
I have ordered the video from Bruce
Why are you reluctant to go the turbo route?
Extra complication and a bit concerned with stock turbo over rev at high altitude
with the stock 90-92 waste gate. According to Dave Leonard that actually has
a 91 turbo engine the 90-92 waste gate has two 3/4 holes which might be enough
but not even Mecanair has tested it at altitude. It would be wise to devise
some sort of turbo tachometer to monitor the RPM and keep it under 125,000 or
so. BTW the earlier 86 - 89 turbo engines should be avoided due to exhaust
manifold and turbo cracking. Later 90-92 manifolds and turbo's can be retrofitted
however. I am not entirely sure about these exact year divisions.
1993 and later turbo engines have a very complicated and heavy sequential turbo setup
that is inappropriate for aircraft use. In those cases you will have to make a
manifold
and buy an off the shelf Garret TO-3 or TO-4 turbo and waste gate.
I would appreciate some more advice as I am not sure of how to proceed from here. I
am a bit impatient, do you think I can open the motor without a manual and still
not do serious damage?
Yes I think you can. Make sure you label everything very carefully as to where
it came from if you plan on reusing the part.
I am going to order the Tracy Crook PSRU and ignition and EFI units, is this right
way to go?
Absolutely. Tracy has more experience with this sort of thing than anybody. PL
Thanks for you help
Mike
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org