Ernesto Sanchez wrote:

I would like some 2" and 3" tubing too.  Is it available??  How are "We"
going to bend the 3" Paul??
Ernesto

We will have to find someone with a mandril bender. The 0.035 wall should
not be of
too much trouble to bend. The three inch size I had in mind for muffler down
pipes
but SS might work as well as the gas has had a chance to cool somewhat.

Jeff Spitzer wrote:

3"x.035 might by next to impossible to bend due to large diameter to wall
thickness ratio.

Jeff Spitzer

Good point Jeff. I notice that Burns only offers pre bent 3 inch  SS in 16 gauge
or .065 thick. I guess I will have to cut pies in it and weld it to
form bends for down pipes from the muffler. Either that or use
two two inch down pipes.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org