Vandbrobertson wrote:
Don't plan on cool at altitude!
A Glastar pilot with a Suburu 2.5 liter reported 90 deg. F at 10000 ft
going
home from
Oshkosh. Water temp exceeded 240 deg at that altitude.
Vince robertson
And he kept flying with his water temp at 240 deg F?
It is not unusual to get high temps at altitude out
here in the west.
BTW Sounds like his rad ducting or some other
part(s) of his cooling system were improperly designed. Got any pictures?
Paul Lamar
Tracy Crook wrote:
If that Sube was normally aspirated, Paul is right. In my experience, the
lower cooling capacity of thin air at altitude is more than offset by the
lower power (and cooling requirements) from the engine. Overheating at
altitude due to thin air generally applies to turbo or supercharged engines
which can make sea level power up high. I ran into some high temps at
altitude (10,000 - 14,500 ft) on the way home from Oshkosh as well but my
coolant temps never went over 190 F at full throttle. As Paul will tell
you, [over and over again :-)PL ] my cooling system is far from state of the
art and was built as a "low cost technology demonstrator".
I finally got around to finishing my tests on cooling when using the heater
outlet on the 13B. Instead of feeding both rads from the water pump housing
(note that this is NOT literally the water pump outlet) I tried running one
of the radiators from there and one from the normal water pump housing
outlet. The first thing I noticed was that the pressure rise at high rpm was
lower than before. Pressure in the engine block goes up with water pump RPM
by about 7 - 8 psi between idle and 6000 rpm. This was reduced to about 3
psi when using the heater port. I could not measure any significant change
in coolant temperatures. After every flight I noticed that my coolant level
was down a couple of ounces. I kept topping it off but got the same results
every time so I don't think it was just purging air pockets. After changing
back to original configuration the coolant stopped disappearing.
Not sure of the cause but I think the heater port flow caused a
corresponding reduction of flow to the other side of the engine. That side
is the "cool" side of the engine which doesn't really need the cooling
anyway but the exhaust ports are also over there. The reduced flow around
the exhaust may have allowed for some local boiling which in turn caused
some coolant to be burped from the system. It should be noted that my
system has the absolute minimum in water-air separation volume which is
about a 5 ounce volume formed by the top of the waterpump housing where my
pressure cap is located. The simplicity and low weight of this arrangement
was one of the compromises I made. Coolant recovery is handled by an
unpressureized overflow bottle fed from the overflow port on the stock Mazda
filler cap fitting. Bottle is about 20 oz. which is a bit small. 32 oz
would be about right.
My efforts to clean up the air duct to the oil cooler (stock Mazda) paid off
well. Oil temps were reduced by about 15 degrees F. Made the fiberglass
work (yuck) worth it. Just shows you how important the shape and size of
these things [ducts] are.
Just getting back on track here after the redrive input shaft thrust bearing
fiasco. Finished retrofitting the last customer returned gear box with the
new bearing yesterday. Thanks to all who have been waiting patiently. Now
back to building new ones.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
YES!!!!! I can hardly wait for mine :-) Going to mount my engine & re-drive on
the golf cart dyno.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org