Paul wrote:
This shows the air box, overflow tank and modifications to the water
pump neck for the parallel cooling system. The two hose clamps
above the front end housing are on the water plumbing "Y" to the
two rads. The air for the carbs comes up from the bottom and
makes a 180 into the carb airbox. I suppose there is provisions
for carb heat down there somewhere.
Good job Finn. Now I see the heat shield on the muffler for the water
hose.
Paul Lamar
Finn Lassen wrote:
Look again. The scat tube to the rear of the airbox is for carb heat. There is
a flap door on the inside rear of the airbox. Normal air is ram air directly
through front openings into the airbox - approx 1/2 of full airbox diameter.
There is a flap that closes off that opening when carb heat is applied.
Looking closer, you'll see that there are two hoses - one from each radiator
all the way to the water pump housing. The two hose clamps are for a T into
one of the hoses and from the front housing. As Ed Anderson pointed out, it's
important to connect that point into the return line.
That would bypass some of the hot water returning through the cool side of
the engine. Sort of like having the heater on. Should reduce the restriction
to water flow in the engine and improve the water flow through the hot side
of the engine.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org