"Rogers, Bob J." wrote:

Based on all that I have read in available literature and from comments on
this forum, it appears that the use of peripheral port intakes provides a
significant advantage in power for the rotary engine.  Because of the
agressive timing on a peripheral port, however, it seems that a major
problem associated with this type of intake is very poor idling
characteristics.  How bad is it really?  I know that Powersport is using a
butterfly valve at the port opening to improve air  flow characteristics

and

velocity at low engine speed.  They also have intake tubes that are less
than 1 and 1/2 inches in diameter, which increases airflow velocity and
improves idle characteristics, when compared to the huge port openings

that

Racing Beat offers.

Before I spend a lot of money on the modifications necessary to convert a
Mazda 13B to a peripheral port intake engine, I would like to get a more
thorough discussion of the pros and cons, along with the technical aspects
of what effect the peripheral port has on overall engine performance.

Does

anyone know of a book, treatise, technical paper or other comprehensive
discussion on the subject, including actual data on just how poorly the
engine really idles?  I am hoping that someone has already been down this
road and has written extensively on peripheral port engines.  Is anyone
currently flying with a peripheral port engine, other than Powersport?

Any suggestions would be appreciated.  If you know of a technical paper or
book, I would like to know how to get it.  Thanks.

Check our web site below for a list of books and papers.

Paul Lamar

"Rogers, Bob J." wrote:

I had already looked at the impressive list of technical papers shown as a
link on your web site, but none of them seemed to address the questions
posed above, nor did the titles of any of those papers appear to deal with
the effects of a peripheral port intake on rotary engine performance.  If I
missed one, a specific reference would be appreciated.  Surely, this issue
has been analyzed and reported on somewhere.

Bob Rogers

A couple of papers that discuss the subject of P-ports are SAE 920309
amd SAE 841017.

We have had extensive discussions on here about P ports. You might try the
CD. Ken Powell and I are in the process of building a P-port engine as we speak.
We will report its idle characteristics. When Everett and Allan Tolle 
were racing the Power Sport engine in Fl at Sun & Fun the idle sounded 
OK to me. 

Are you building a sea plane?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org