Subject: IO 240 fuel mngmnt -Pulsar crunched
From: Paul
Date: 8/23/2000, 12:02 PM


Keith Miller
08/23/2000 09:38 AM

Vance ,

first of all , i wish Solly and Pulsar all the best with the repairs and hope
that it will be a speedy  in-expensive process, I was looking forward to
seeing this new pulsar .

Was there a reason why you didnt  fit the two seperate valves and the
clockwork linkage , described on your web-site and in the KIS newsletter,
this was a much cheaper solution than the Andair 6 port valve (- specially
designed for katana and the IO240), although having seen the Andair valve it
is a fantastic piece of engineering ( the rolls - royce of fuel valves ).

was it the intention to retrofit something later or was this the proposed
method of operating this airplane.

Assuming the IO240 burns 8 gals per hour , then the return flow was actually
higher than the consumption ( used 2 gals , returned 3 gals  to the wrong
tank), since I have no idea how the  mechanical fuel pump works ,  can
anybody tell me is the  fuel flow rate proportional to the engine speed . in
other words when we taxi , is it also returning  3 gals to the tanks? has
anybody fitted a fuel flow metre ?

keith

Keith - and others
Apparently I did not express the magnitudof the return flow, when I advised Solly of
this requirement, and simpler installation
was opted over simpler operation. In
retrospect, I apparently erred in my
assessmment as to the magnitude of this
return flow. I had told him under some
operating points, the return would be as
high as the consumption, and it is higher.
The fuel pump is a rotary vane, nominally
a positive displacement pump, with flow
relative to rpm. Probably the same pump
as the IO 360 - so over 100 percent of
IO 360 consumption. This results in a much
higher bypass flow than the Bonanza. It
could still be handled with procedure, but
as many of you pointed out - higher work
load during emergency is definately not a
good practice.
A fuel flow sensor is installed in Bill's
Cruiser - between the pump and the "spider"
so it only shows consumed fuel. To my
knowledge no one has measured comparitive
flows (tho there was a similar confusion
during the Voyager around the world flight
where they did not account for return flow,
and switched to single engine operation
while the plane was too heavy - so we are
not the only ones that have been confused by this problem).
Vance

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org