Preliminary Results on Performance Testing of a
Turbo charged Rotary combustion Engine.
Turns out I had this paper mis-filed under Curtiss Wright papers.
Not too interesting as it was a turbo side port 12A with a modest boost of
7.1 psi and 160 HP max. Most of the work was done at a 100 HP level.
IMHO this was the most interesting results of the whole paper.
I have been ranting on here about the importance of measuring
the housing temp down near the combustion chamber. Well here it is.
Note the housing runs in the neighborhood of 340 degrees F while the
water is only 200 degrees F or so. This is for only a continuous 100 HP.
Housing temps will be much higher for higher HP levels. I think 400 to 450
degrees F would be a good limit. Improvements in water flow rate
and heat transfer to the water from the aluminum water jacket
such as internal grooving will show up here.
As I have said several times before this is the real limitation of
how much continuos power you can get out of any engine.
IMHO every rotary engine used in an aircraft should have these
thermocouples. Same as CHT's in air-cooled aircraft piston engines.
Paul Lamar
Ken Powell wrote:
Paul,
Is this where a thermocouple should be installed? I had understood
from previous discussions that it should be installed near the spark
plugs?
Ken Powell
Good question Ken. I forgot to mention that. This is a warm spot but
the hottest spot is right along side the leading spark plug. I will drill
your housings for you if you wish when I install the p-port.
See the attached chart.
BTW does anybody have a picture of the milling operations Mazda does on the
1993 and later REW rotor housings?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org