Subject: SAE paper 820354
From: Paul
Date: 8/24/2000, 8:40 AM

Marc Pedings wrote:

Paul wrote:

Preliminary Results on Performance Testing of a
Turbo charged Rotary combustion Engine.

Turns out I had this paper mis-filed under Curtiss Wright papers.
Not too interesting as it was a turbo side port 12A with a modest boost of
7.1 psi and 160 HP max. Most of the work was done at a 100 HP level.

IMHO this was the most interesting results of the whole paper.
I have been ranting on here about the importance of measuring
the housing temp down near the combustion chamber. Well here it is.
Note the housing runs in the neighborhood of 340 degrees F while the
water is only 200 degrees F or so. This is for only a continuous 100 HP.
Housing temps will be much higher for higher HP levels. I think 400 to 450
degrees F would be a good limit. Improvements in water flow rate
and heat transfer to the water from the aluminum water jacket
such as internal grooving will show up here.

(snip)

Paul, is there any indication on the exact positioning of this thermocouple?
As already thoroughly discussed, the rotor housing temperature could vary
somewhat, especially around the spark plugs.  In other SAE data that you have,
is this area (where the thermocouple is shown on 820354) prone to a large
temperature gradient?  I don't recall any discussion on it and I can't find
any data in my texts...  I would assume there isn't much, but it doesn't hurt
to check!  Good find, Paul!

Marc Pedings

You guys are getting really well educated on all this stuff.:-) Or great minds
work in similar ways. See Ken Powell's question above.

BTW these NASA guys were ahead of even Mazda on this turbo stuff.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org