Subject: Electric variable pitch props & cooling.
From: Paul
Date: 8/26/2000, 4:50 PM

"Ray Richardson Jr." wrote:

Dear Paul;

The  72"  3 blade MT electric constant speed prop we are testing is
a early version and has the smaller electric motor and does not respond
nearly as fast as their new design. But we have found the prop limits
were allowing the blade angles to go to the minimum pitch setting.
That is why it could not catch up with our acceleration. We have adjusted
the electric minimum limits to a much higher pitch angle and now
the prop works great!!
We now are a OEM approved sales outlet for MT Props.

Update on our cooling;

We are using the same cooling design that cooled Powersport's earlier RV-4
for 10 years. Except we are using a custom oil to water cooler, where
the earlier RV-4 used a 10x12 oil to air radiator above and behind
the engine with a through the upper cowl exit. We should have added
that surface area in our selection of our main radiator. We now have added
that upper radiator still using the oil to water exchanger. Resulting
flight test
yesterday was max. water temp. as measured at the front casting after
the 2 hot zones was 210 degrees. F.,  Oil temps. still climbed to 230
degrees. F.
OAT was 80 degrees.

Next test tomorrow we will use the upper cooler as a oil to air.

We have concluded the stock size cross flow radiator we purchased
needs to be larger. The nose gear bracing on the RV-6A does reduce
our options,  however we have found a supplier for the correct size
and we will update.

Our reasoning remains to have a large surface area of radiator, and
defuse the high speed air to the slowest speed possible through the
radiator, and accelerate the air back to highest speed possible
at the outlet. To optimize this, requires distance and area, in front and
behind.
Our cowl and radiator location accommodates this.

You must have noticed we had build a duct around our exhaust
out through the low pressure zone behind the radiator. This intakes
cold air at the engine exhaust outlet and the exhaust heat is carried
out without going through the radiator. This first experimental duct will be
improved.

Depending on where we put our temperature probes the inside cowl temperature
averages 10 - 20 degrees higher than OAT during flight.

You know we did our 40 hours in 13 days and flew to Oshkosh the 14 day.
We worked our butts off to finish this plane and get there, Our team
then took a much needed 2 week vacation.

The cooling issues will be improved shortly. Next we will start on drag
reduction wheel pants, ect.

When we are done we may hit VNE in a modest climb.

Tally to date we have orders for  7 engines, and a 8th reduction drive.
5 glass cockpit computers,  with a rocket customer wanting us to
build him a 320 hp. 3 rotor.

We have updated our web site at http://www.powersportaviation.com

Thank-you for your continued interest.

Ray Richardson

OK Ray. Thanks for the update. I will see you in Apple Valley at six AM on the 
day of the race :-) There will be $500 cash waiting for you in AZ if you can average
200 MPH for the 300 miles. If you want to get out here a couple of days early
you can store your airplane in my hangar.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org