Subject: Rotaries and BSFC....cooling demands
From: Paul
Date: 8/28/2000, 9:52 AM


Paul:

Is there a chance that the ordinates on the graph showing BSFC are wrong??
g/hp-hr is a very unusual metric.  Normally it would be g/kw-hr! in metric or
bhp/hp-hr in US/UK.

As it is the numbers plotted work out to BSFC of approx. .57 to .64 or so 18
gph @ 200 hp).  Quite high.  If one only converts the "g" of fuel to "lbs" of
fuel the numbers are a bit more reasonable like .48-.56......if one assumes
the scale is indeed g/kw-hr then the BSFCs are approx. .42-.49 (15.8 gph @
200 hp).....still not terrific, but pretty much in line with what Tracy Crook
and Mosur, etc...are reporting for airborne fuel consumption at their cruise
efficiencies.

No. I think it is grams per HP hour.
A BSFC .65 is typical for a turbo aircraft piston engine during takeoff and climb
power. 0.55 is typical for a normally aspirated rotary max power.
Tracy was able to get down to about .47, he figures, at high altitude
lean cruise and maintains his fuel burn is the same as a Lyc RV4 side
by side.. same speed. Most people run their Lyc's 50 to 100 degrees rich
of peak to save the exhaust valves. It is only if you run then
50 degrees lean of peak do you see numbers like .43 to .45.

BTW Klause is fond of running his Continental O-200 100 degrees
lean of peak at altitude and he recently had a valve head drop
off over the mountains. Fortunately he was only 20 miles out
and made it home to Santa Paula.

To get good BSFC with a turbo rotary at cruise use a variable pitch prop,
slow the engine and up the boost to maintain the HP. 
That reduces engine friction HP losses and improves the BSFC.


I am a new member deciding on whether to go 13B Turbo or 20B on my RV-8 for
here in Colorado and Wyoming, Utah, Idaho to deal with the altitude.

Also am just about finished with a pretty accurate study on what BTU/hr
requirements are for the water and oil heat transfer devices.  At least that
gives one a BIG head start on selecting the proper cooling setup.  Perhaps
someone has already done that, but it has been a real education in SI and CI
(spark ignition/compression ignition) engines for me anyway.  I will send it
as an attachment when fiinished, if you think it might be valuable.

Regards,

Doug Dempsey
Bellvue, CO

We look forward to seeing your numbers on the BTU/hr
requirements. Al Geitzen and others have done some of that
work on here in the past.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org