Ed Anderson wrote:
Hi Folks,
Just thought I would give an update on my lack of compression problem.
Summary Conclusion:
I believe that the absence of the protective oil and the high humidity
conditions over the intervening weeks all contributed to the rust I saw on
the rotors and I now believe that the apex seals are frozen with rust.
So my advise is - if you ever have a case of severe flooding, immediately
add oil to the combustion chambers and rotate that son of a gun to spread it
back over the metal surfaces that the gasoline may washed it from
Narrative of Event
I spent most of Saturday pouring various things into the combustion
chamber. I tried Marvel Mystry Oil, lightweight oil, heavy weigh oil and
urine (just kidding) but with no success. We (had a couple of friends
helping) spun the propeller until our arms 'bout fell off. Used the starter
as well. Tried it with plugs in and plugs out, but no joy. In fact, could
not get compression up on a single rotor face.
Monday, I removed the exhaust pipes so I could get to the apex seals and
may have found the cause of the problem - RUST! I intended to try to
compress the apex seals through the exhaust port (hard to poke past the
exhaust splitter, but possible). I could not get the seals to move even
though I pressed on them with a brass rod and later a screwdriver. It
should be possible to move the seal against the apex spring a slight amount,
but I could not get them to move at all.
I have come to the conclusion that the seals may have rusted in their
slots. The reason for this hypothsis is that there were some spots of light
rust on the rotors near the apex seals. It appears that the flow of liquid
gasoline thought the combustion chambers and seals, when my old EFI
malfunctioned, likely removed most of the oil at that time. After the
liquid gasoline event (flooding), it was probably 5 weeks before I attempted
to start the engine as removed the old harness, rewired and waited to
install Tracy Crook's EFI. I had the intake manifold off for part of that
time and the holes plugged with rags(mainly to keep the dirt dobbers out)
and it has been high humidity conditions over the recent weeks. So I
believe that this combination of things have resulted in frozen apex seals.
So I am now yanking the 86 NA six port and will be installing the Turbo
II (with considerably better compression than my six port ever had) I have
in the workshop. That will give me an engine configuration very similar to
Tracy Crooks (yes, this turbo has the NA rotors) and hopfully similar
performance. I Will keep you all informed.
Ed
Ed Anderson
Matthews NC
eanderson@carolina.rr.com
Let me first say I have no idea what is wrong with Ed's engine.
Just to put things in perspective I will say he has a very unusual
installation with a plugs up configuration. He has no oil sump in the
usual sense of the word. There is a flat plate on what was the bottom
of the engine which is now the right side of the engine. Consequently he
has an oil level in the engine much higher than usual I would suspect.
No telling what is really going on. I have never heard of rusted apex
or side seals. I am sure it is possible. Most engines that
have stuck seals are stuck because of carbon build up. It is also possible
to overheat the apex seal springs and have them lose their temper
and consequently collapse. Under normal operation the center of
the apex seal runs about 500 degrees F. With a lack of apex
seal lubrication (and consequent cooling) this temperature can go much higher.
Also an interruption in cooling oil supplied to the rotor can also
cause the rotor and springs to over heat and fail I suspect.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org