Subject: Turbo Match for 13BT
From: Paul
Date: 8/28/2000, 9:19 AM


Roger Enns wrote:

Have you considered Garrett/Allied Signal's method of monitoring turbine
speed?  They simply mill a flat on the shaft, and drill and tap the center
section casting to accept an inductive prox sensor.  The prox sensor aims
at the shaft centerline, and is threaded down to provide suitable voltage
output as the flat on the shaft passes during rotation. Counting pulses
gives you rpm.  I've seen a simple Fluke meter with frequency capability
used to display speed if the budget prevents a more elaborate method.  The
turbine/shaft must be rebalanced after milling the flat. Consider
replacing turbine/shaft once testing is complete.

Paul responded:

The mag pickup is going to run real hot threaded into the turbo bearing
housing.

Russell Kent wrote:

So paint the flat white, and use your fiber optic sensor instead.

Russell Kent

That means I have to take it all apart and mill the flat and then
balance it. The easy way is bolt a magnet under the compressor wheel
nut as mentioned by Jeff or did you read that far? :-) 
Shame on you Russell :-)

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org