Bill Freeman wrote:
Castrol 20W-50 is a VERY good oil for four-stroke piston motors, not
too sure how it might cause any problems for a rotary. Perhaps the
water
suggestion is correct, and you didn't flood it with gas, but water. Wet
the
plugs and rust the tip seals. Did you sump the tanks, or omit this
(assuming
it was a ground test and you might have skipped thorough preflight).
Bill
Ed Anderson wrote:
Yes, I fill the gas tanks after each flight before putting the bird to bed
to avoid accumulating moisture in the tanks. I had not drained the sump
before the flooding incident as I was not intending to fly. So I can not
state for certain that there was no water in the tanks. However, in my two
years of flying it I have never found water in the gasoline while draining
the sumps.
I agree, I don't think the sump oil is a factor. Should not be any in the
combustion chamber and those are sealed from the oil sump by the oil "O"
rings which I replaced approx 20 hours ago. Also, if sump oil was migrating
into the combustion chamber I should have seen smoke from the exhaust and
that condition has not occurred even on start up.
I will drain the sumps next time I am at the hangar and see if any water is
present although at this time not certain what the absence of water would
mean. Could mean no water in tanks at any time or I pumped it all out
during the flooding incident into the engine.
The only reason I am suggesting rust is that it was clearly present on the
rotor surface near the apex seal area on a couple of the faces. It appears
the carbon protected other areas. But, again speculation on my part.
Ed
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org