Chris Gentry wrote:
Related question: The normal oil source for the stock turbo appears to
have gone
through the engine and then goes to the turbo which means it is already
very hot
oil. My T04 is not water cooled so I would rather lubricate the turbo
with cooler
oil. Any suggestions on how I could safely do this?
Regards, Chris Gentry
Glasair Turbo Rotary
Dragonfly Turbo Subaru
Grumman Cheetah
A "T" in the oil return line from the oil cooler? Are you using a
metric to AN adapter where the oil cooler line goes into the block?
See picture with red arrow. Banjo fitting shown.
Paul Lamar
Chris Gentry wrote:
Thanks Paul,
I am using the AN adapter and it sounds like a very good place to use a to
tap off for the turbo (using a "T"). Do you think there would be a problem
with that much pressure from that point or is it pretty constant through out
the engine?
Regards, Chris Gentry
Glasair Turbo Rotary
Dragonfly Turbo Subaru
Grumman Cheetah
bill martin wrote:
Bill Martin wrote:
If you look at the banjo bolt,there is enough meat to drill and tap to 1/8" > pipe for a fitting.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org