Subject: How to mount 13B to a cheap engine stand
From: Paul
Date: 9/5/2000, 10:56 AM

norm2 wrote:

I had all but given up hope of using my new engine stand (another Harbor
Tool bargain, plus free shipping!) since the 13B doesn't seem to lend itself
to the typical method of mounting it using bellhousing bolt holes. But in
the Haynes manual, there are a couple of pictures
showing an engine on a stand, and you can just catch a glimpse of a
special bracket that goes between the side-mounted engine and the stand.
It's shaped like this when looked at from above;

Try doing it like this:

http://home.forbin.com/muzzy/cozyweb/cozyimageweb/PIC00466.jpg

This uses a cheap engine mount bolted to the bolts and holes that hold the
accesorie drive casting.  I torched out some of the engine mount to provide
clearance for the oil dip stick and such.  The offset bracket works also, I
thought this would be a bit more solid (and faster).

This allows you to assemble and disassemble the engine as shown in Bruce's
tape.

Note also the oil pan plate style engine mount.  You need to use the low
profile Barry mounts to allow for clearance for the oil cooler fitting and
lines.

Here is another picture of it:

http://home.forbin.com/muzzy/cozyweb/cozyimageweb/PIC00465.jpg

And for those who would like a picture of what engine performance you are
trying to match, here is a Lycoming IO360A3B6D:

http://home.forbin.com/muzzy/cozyweb/cozyimageweb/PIC00459.jpg

Regards-
Norm Muzzy

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org