<<bcgardner wrote:

I'm a bit perplexed by the discussion on making the Harbor Freight

engine

stand fit. I bought one and it worked. I had to buy extra long metric

bolts

at the hardware store and used washers and short pieces of pipe to

shim

the

engine out from those adjustable arms on the stand. I bolted it in to

the

rear of the engine and used the shims to hold it out, so the

flywheel/flex

plate had clearance from the stand.>>

Tracy Crook wrote:

If all you want to do is mount the engine on a stand, that's fine.  However,
the engine MUST be disassembled by removing the flywheel end housing first.
Pretty hard to do this when its bolted to the engine stand.

Tracy Crook
rws@altavista.net
www.rotaryaviation.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org