Subject: Wankel charge cooled rotors?
From: Paul
Date: 9/6/2000, 5:05 PM


Wankel also had an oil cooled rotor design (our basis for the heavy-fueled 40
Series at RPI). There were no bearing problems and the volumetric efficiency
was of course better, but the rotors were poorly designed and bad castings to
boot -- so failures did occur in our testing (albeit at higher hp than the
design point). Charge cooled rotors are just a bad idea IMHO. Unfortunately,
the downside to oil cooled rotors is the need for a pressure pump, sump, and
rotor oil seals (very difficult to make).

Jon

I am looking at experimenting with just teflon coated silicone O-rings
and nothing else for oil seals. Good for 500 F and low friction.
New technology you know :-)

Paul Lamar


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org