Paul, The 75hp model is charged cooled. It was installed in a revolution
helo , I believe, successfully. The aircraft itself failed.The fuel injection
is electronic and was made by holley in the U.S.There is an awful lot that
can be done with intake runners and exhaust tunig as that is non-existent on
this engine.
I am not sure how successful that would be as the charge must pass through
the rotor which limits any type of porting.
I happen to have one of these engines in my shop.The water pump
and starter are a beautiful package on a sand cast casting cluster on the
front of the engine(depending on how you want to look at it)The intake
runners appear to be an afterthought in being two right angle bends with two
throttle plates respectively.The injector bosses are pooly welded in place
appearing to be an afterthought so close to the ports that I wonder how ang
good mixing takes place. I asked the factory if the H.P. could be raised and
in very typical German fashion I was told that was impossible. I asked if
the engine was able to be turbocharged and again was told that equally was
impossible. You wonder why they were in business being so unresponsive to the
market. I would be willing to bet that Jon Lauter might be enticed to help us
in the quest to buy the appropiate tooling and rights to manufacture this and
hopefully a better engine.I could help with the turbocharging.I found a
beautiful micro turbocharger that probably would work quite well. I would be
interested in being a player in this affair. JIM DANA
Another drawback to charge cooling is the rotor and main bearings must be
roller. Roller bearings in the rotor orbiting around are a inertial nightmare
at high speed. With a cast iron rotor and charge cooling the engine might have
been right out at the inertial and thermal limits. This could explain their
reluctance to go with a turbo.
Mazda put billions into developing their version. Far more than Wanke1 GmbH.
If I were building a rotary I would go with the Mazda design.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org