Subject: Water pumps & Velocity Motor mounts
From: Paul
Date: 9/6/2000, 4:08 PM

Ray Richardson of Power Sport and I had a phone conversation today.
He does not always have time to respond to emails.
He installed a flow meter in the Mazda cooling system and is 
seeing numbers like 14 to 19 GPM. Not good. He promised to get
some more scientific numbers like GPM verses engine or pump RPM for us.

They also tested a highly hyped racing  electric water pump that 
claimed 30 GPM and got 9 GPM out of it with no load or back pressure. 
So much for the 100 MPG carb  or perpetual motion machine.

They have done away with the water to oil intercooler and now have
an oil rad mounted up behind the engine exiting air at the top of
the cowl. The oil is still running hot but the water cooled off.
Duh! :-)

They now have 65 hours on the plane in the short space of about 
a month. At this rate they will catch up with Tracy in about a year 
and a half to two years depending on how many hours a month
Tracy flies. On the other hand it gets real cold up in 
Wisconsin in the winter time.

Ray also said he would be glad to build Velocity motor mounts
as he has at least one order for a Velocity Power Sport engine
installation. Make sure you are on the same page as far as
thrust lines are concerned as his thrust line is two inches
or so above the the e-shaft center line. So if you are using
Tracy's re-drive and Power Support motor mount your thrust 
line may vary. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org