Subject: Casting scaled down Mazda & Mini 500 mods.
From: Paul
Date: 9/7/2000, 9:34 AM


 > The group
 > talked about water injection before... That is a wonderful way to cool the
 > combustion mixture as well as scrubbing the internals with superheated
steam
 > to take off all the carbon. If we could increase the heat transfer to the
 > walls and then to the water jacket two systems may work out better in this
 > engine.since the water injection could be used only in times of thermal
 > overload (high H.P.) you really would not use up that much water . The
 > mixture would be cooler and the heat transfer would be better and therefore
 > the engine would not have to "heat sink" as much in the metal internals.
 > Just a thought.... maybe you and Rickie Stitts (hi Rick) might want to
 > comment on this .    JIM DANA
  >>

Hi Jim Dana...

I think there might be a problem depending on where the water injection is
input into the system.  I think one would want to keep the internal rotor
temperature constant.  Injector spray onto the rotor would probably cause
thermal cycling of the casting which would show up as metal fatigue cracks
later.

I understand that water injection on two cycle tuned pipe section allow for
greater torque.

On a second note Jim...Just finished Mini T/R gearbox calculations. Have
three versions ready to start life testing on.

I've been programing my spread sheet to recalculate proper wall thickness for
M500 main shaft at various HP levels. Working on improved Main shaft,
internal oil pump and filter for M/T.  Hope to finish secondary mods to MSS
in next 30 days. Like adjustable dampener to compensate for wear and belt
alignment pulley adjustment.

Currently having tooling made for two part polyurethane ISO mount for upper
MSS and transmission mounts.

Rick Stitt

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org