Subject: An automotive but non-rotary question..
From: Paul
Date: 9/12/2000, 3:45 PM


bcgardner wrote:

Paul,

Can I ask you a non-rotary question?

I have a 90 Ford Taurus that has some kind of electrical problem I've never
seen before. It's probably simple but...

Here are the symptoms. The car starts great when everything is cold.
However, when the car is warm, the starter barely turns over and actually
has left me stranded when it fails to start. A trip of 10 or 15 minutes is
enough to set this in motion.

There is apparently a lot of current running through the circuit, even
though nothing is happening. If I hold the starter on, though it is barely
cranking, I can burn the insulation right off the ground strap of the
engine.

Could be a bad connection on the ground strap. Use a digital volt meter
across the connection to measure the voltage drop when hot. If it is relatively
high lets lets say 1 volt for illustration purposes and the starter is drawing
say
300 amps the wattage is 300 watts which will quickly heat the strap.
Since the starter is slow I suspect the drop is much higher
than one volt if this is indeed truly the problem. The starter could
also be shorted when hot but that would soon drain the battery.


I figured maybe my starter was bad. I replaced it this weekend. Same
symptoms.

Then I thought perhaps my battery was defective, developing some kind of
internal resistance after it charged a while. I replaced it with another
battery. Same symptoms.

Let the car cool for 15-20 minutes and the car starts up fine.

Any ideas?

Thanks.

Barry Gardner
Wheaton, IL

Hans Conser wrote:

My bet is internal corrosion on the positive cable from the battery to the starter.

Hans
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org