Finn Lassen wrote:
The only "porting" I've done is enlarging the exhaust holes in the rotor
housings to be as big as the inside of the steel inserts allowed; removed the
"turning" valves in the intake of the end housings and smoothing the 90 degree
angle there with JB Weld. Exhaust path should be more than 3 sq inch all the
way.
BTW, this was at a gross weight of about 1100 pounds. Top speed is supposed to
be 207 mph (at 8000') with 150 hp. So this means I have a lot of drag I need
to get rid of. Need to add gear leg fairings, wheel pants, cowl cheek
extensions and flap fairings. I wonder if that will really give me 27 mph or
if I'll also have to address cooling drag.
Finn
Drag is always the primary factor in top speed. Top speed is roughly
proportional to the cube root of HP.
This only works up near top speed. At lower speeds drag due to
lift becomes a major factor.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org