Subject: Powersport update and water pump flow
From: Paul
Date: 9/14/2000, 11:31 PM

"Ray Richardson Jr." wrote:

Paul and friends;

Our progress continues,  we now have 71 hours on
our 215 hp. Powersport rotary engine RV-6A  in 8 weeks

Performance with the 3 blade 72" MT electric constant speed
prop. WOW  take-off  250 ft,   rate of climb 2200 F/min.

Engine orders to date,  8 engines and a 9th reduction drive.
we do sell the reduction drive separately.

                 cooling updates

We had to reshaped our air inlet to remove the upper
diverter to fix the air flow problem.

We permanently closed the cowl flap as it was no longer needed.

We have installed a 10 x 13 oil to air cooler above the engine
to get added cooling capacity,  and allow us to test the
water and oil cooling systems separately.

Water temps now run 160-190 F. depending on power and climb angle.
oil temps still running higher 190-220 F. We can not hold full power
at climb for more than 2 minutes without exceeding 220 F. oil temp.
      see our testing and solutions below

Paul;

You had asked me to report our pump tests as we have tested
the stock Mazda water pump flow rates. They are as follows;

Water flow through the running engine without radiator

1500 pump rpm 10 GPM at 1.75 psi
4000 pump rpm 27 GPM at 8.5 psi
5800 pump rpm 36-37 GPM,  over 10 psi ( meter pegged)

Special note, when we diverted the 5 GPM we had been using
from the water pump to our oil to water cooler at all of the above sites,
with or without diverting pressure water, the flow rates did not change

Same tests as above, except also running through
our cross flow radiator we were advised to use.

1500 pump rpm  9 GPM at 5 psi
4000 pump rpm 12 GPM at 5 psi
5800 pump rpm 19 GPM at 5 psi

Conclusions

1) We will increase our water pump speed by making a larger
    diameter driver pulley on the eccentric shaft.

2) the cross flow radiator appears to have too much water flow
    restriction as pressure and flow went way down. We have ordered
    a straight through radiator design and will evaluate the difference flow
    and pressure rates.

3) After we install the new radiator we will go back to our oil to
    water heat exchanger with a larger water porting to deliver the
    10 GPM we calculated was needed for our horsepower.
    The larger diverted water flow does not appear to reduce the
    engine's water flow rate and will greatly enhance the oil cooling
    with less oil flow restriction than the oil to air cooler provided.

4) Remove the Temporary oil to air cooler above the engine and block the
    upper cowl hole also improving the air flow through the new radiator.

5) reduce the inlet cowl hole size under our prop,
    to the inlet amount actually needed.

The rear radiator location does work well with our cowl improvements
and we expect also show a overall reduction in drag when we are done.

I sold my Cessna 172,  our test plane is much more fun to fly.

Ray Richardson Jr.

WWW.powersportaviation.com

Ray, were in the system was the pressure tap on those pressures quoted above?
I take it the pump flow without radiator  was from a bucket through the 
engine back to the bucket? If so how far below the water pump was the 
water level in the bucket?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org