Subject: 150 HP at 5500 RPM?
From: Paul
Date: 9/15/2000, 3:43 PM


Bill Freeman wrote:
So that makes the BSFC 0.6.  I think you need to look at some other
RV4s and see what HP they are pulling at 180 mph to help nail down
the HP and thereby, the BSFC.   For instance, at 180 hp the BSFC is
0.5 and at 0.42 BSFC (not realistic to expect) the HP comes out to
214 HP.  Finn needs to try leaning the F/A to stochiometric (with
the
Oxy sensor) at this power setting and see how the engine likes it.

Excellent to get good flight test data like this,  THANKS, Finn.

Bill

Finn Lassen wrote:

Ok, it's an RV-3, really!

I'll be happy to try to lean it to a reading of between .6 and .7 volts
on
the oxy sensor, but please tell me, how?

It's really hard to remove the carbs, remove the jets, solder them shut,
drill a number lower, remount jets and carbs, all while flying :)

Finn

You should have put one of Tracy's EFI's on there Finn :-)

Paul Lamar


Tracy Crook wrote:

 I hesitate to discourage any EC2 sales :-)  but those of you using carbs
may want to try a variation on what I did when using them.

This can be accomplished in several ways.  If I ever go back to carbs, I'd
install a very small additional throttle plate feeding the intake manifold
which meters only air. At altitude, open it up enough to lean the mixture.
Only drawback is you must remember to close it before reducing throttle,
otherwise the engine could go lean enough to stop.   Another approach when
using multiple carbs (like Finn & I) is to jet the two outside carbs lean
for operation at altitude and jet the center carb rich enough to run right
at sea level.  Use side by side throttle quadrant knobs (like on some twins
and jet airliners)hooked to separate throttle cables and advance them
together on takeoff.  At altitude, throttle back the center carb to lean.

On a side note, it was interesting to me that the 6 port 13B would develop
about 90% power when fed from the outside ports alone.

Tracy Crook
rws@altavista.net
www.rotaryaviation.com


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org