Paul wrote:
Bill freeman may have it. [Tom Jordans email add) He is not on the list.
Wait a minute I will search old messages. He moved though.
Tracy probably has an update email for him.
That muffler did not work very well. You could look inside and
see the baffles inside glow orange to the point they were
near transparent. I was up there when he was running it.
It would not be long before it spit out
its guts. the other problem it had it was frying the prop.
Best to use a simple tangential muffler with no guts and bring the
outlet further out on the prop disk.
Well, if that's the case, no need to contact him. If I move the exhaust
farther out on the prop disk, I can actually route the "tailpipe"
through the side of the prop duct to exit outside and not even go
through
the prop at all.
BTW that super charger might be the way for you to get a lot
more HP at lower RPMs.
Paul Lamar
Perry Mick wrote:
The only advantage I see to superchargers is you don't have to deal with
the heat of the exhaust. Otherwise the turbocharger would still be the
way to go.
On another issue, I took the thermostat out of the oil cooler this
morning
and put the plug in the bypass hole. That hole is the perfect size to
use
a 1/8 NPT plug tap. At least it is in the 1982 RX-7 oil cooler I'm
using.
I assume the '86+ are the same. Only took 10 minutes to do the job.
The bad news is it didn't make any difference in my oil temps.
Also, I've been running 80 avgas for the last 20 gallons, no effect at
all on the oxygen sensor. One time about 6 months ago I ran a 50-50
mixture of 100LL and car gas (20 gallons), and immediately got gray lead
deposits on my prop and in the exhaust exit. I don't see these deposits
with the 80. According to info I found on the internet, 100/130 has 4
grams of lead/gallon, 100LL has 2 grams/gallon, and 80 has 0.5
grams/gallon.
Also, when I ran the 100LL, it was too short of an experiment to see how
it affected the O2 sensor. The computer never indicated the O2 sensor
was
failing, but I remember when I shut the engine down after a long flight,
it didn't idle as well at 800 RPM as it usually does, possibly
indicating
that the O2 sensor was beginning to get fowled.
Anyway, the idea is on cross-countries, to search out mogas, then 80,
and as
a last resort, 100LL. When is this 82UL supposed to show up anyway?
--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org