Subject: One port center housing
From: Paul
Date: 9/18/2000, 10:50 AM


<<  I wonder what would happen if this
 partition between the ports were ground away. I am sure the engine
 would still run well. I just wonder if it would generate more power with
 one larger total area center intake pipe and no skin friction drag for
 the cast iron partition and less skin friction drag than the
 normal two smaller center pipes. Pipe tuning for the center ports
 of course would no longer work. Lynn have you ever heard of
 anybody trying this?

 BTW Finn ideal for three carbs.

 Paul Lamar 

I have not seen it done. Flow velocity would be way off with the mixture
arriving in a big room. But that may not be all bad. With two housings
pulling on the single runner, it may not be too bad, maybe even higher
velocity than stock. Old British cars like the MG midget and MGB had Siamese
center ports. Two intake valves using one intake runner. It is not ideal, but
it works. A few weeks on the dyno would get you in the know on this one. A
multitude of combinations of runner lengths and cross sections would be
required. All of the combinations would be tested with different header
lengths and timing settings. I have not had a dyno of my own for years. It is
the only way to determine what is good and what is not. I miss it every day.
Lynn

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org