Mike Pienaar wrote:
Following on the post re coolant mass flow capacity:
Could someone please explain, in terms that an accountant could
understand, why the
addition of glycol to water alters the ability to absorb heat.
Why would you want to use a glycol mixture if it degrades your cooling system
efficiency by 50%?
Is there any thing that absorbs heat better than water that could be used
in the
radiator instead?
Thanks
Mike
Two reasons. Freezing and corrosion.
I don't know of one.
Paul Lamar
Mike,
All materials have an inherent property call "specific heat", which
measures the
change in temperature in a material vs the heat energy absorbed, on a per pound
basis. Simply put, ethylene glycol is a different chemical from dihydrogen
oxide (water) and has a lower specific heat.
Paul is correct on reason to use "antifreeze" (the name gives it away) and
all the
commercial radiator mixes are primarily ethylene glycol with a lot of special
chemicals added to prevent corrosion which would be very severe with just
tap water esp for engines with some parts iron and some aluminum - which used
to be unusual but is normal today.
There are other heat transfer fluids available but they are extremely
expensive in
many cases and often are toxic. It turns out the water/glycol is a really good
heat transfer fluid, can be made corrosion resistant and is pretty darned cheap,
and relatively non-toxic, altho you should not drink a lot of it. There are
also
propolyene glycol antifreezes on the market which are completely non-toxic but
I don't think they have much market share. If you ever think you might need to
drink your coolant, use propolyene glycol. :-)
Hope this helps.
Bill
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org