Subject: A few stupid questions
From: Paul
Date: 9/20/2000, 11:08 PM


The glycol has lower thermal conductivity and lower specific heat (the
ratio
between heat absorbed and temperature rise for a given mass).  Water is
the
best cooling media except for corrosion, freezing and boiling issues.
Most
racers run pure water these days I believe.
Jeff Spitzer



Al Gietzen wrote:

Wow, that is really interesting, Jeff.  I had never thought about running
pure H20.  There was some discussion here a while back on the subject, but
as I remember I just decided in my mind to run 50/50 'cause that "was what
worked best."  But since we aims to keep our temps under the boiling point
of H2O anyway, pure water (or high percent water) might be an excellent way
to supplement summer time cooling capasity.  Corrosion shouldn't be too bad
if use is only a few months long and distilled water is used.


Pure water is about 25% better at carrying heat than a 50/50 EG/water mix.
There are good corrosion inhibitors that you can use with water if you don't
need to use anti-freeze for freeze protection.

You might also note that this is offset by the fact that ethalene/glycol
does give some increase in boiling point, so you can run the mix at a little
higher temp.  If I remember right, 50/50 mix gets you to 250 - 260 F boiling
point with a 15 lb cap.  You can find the number on the back of your
anti-freeze bottle.

Al


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org