Wrathall Mark wrote:
If you should return bypass fuel to the wings anyway to dump the heat
load
caused by the pumps and the trip through the engine bay, has anyone
(except
Boeing) tried a fuel/oil heat exchanger? The bypass fuel should still
have
have an adequate temp delta for effective oil cooling, and the tanks (at
least on an aluminum aircraft, should reject enough heat (Pure
speculation
on my part).
All Boeings use fuel oil heat exchangers, as much to get the fuel above
freezing, preventing ice crystals damaging the HMU as for oil cooling.
The failure mode on turbines is for higher pressure fuel to leak into
the
oil, leading to nil apparent oil consumption. On a 13B the balance of
pressures would lead to oil leaking into the fuel, hopefully giving blue
smoke and increased consumption as failure warnings.
Mark Wrathall
Tracy Crook wrote:
Yes, I tried the oil - fuel heat exchanger idea by routing the fuel pressure
regulator return through an oil pan heat exchanger then back to the wing
tank. I still like the basic idea but the specific heat of gasoline was so
low that it takes more than the return flow volume to do much good. In
cruise the oil temp would go down by only 2 degrees F and even less during
climb (when you really need it) due to the lower return volume at high
throttle. Temperature rise in the "wet wing" RV-4 fuel tank was not even
measurable on the instrument I used. Someday I will try this again,
probably on the 20B powered RV-8 planned for early next year. A separate
pump will be used for the fuel flow. Yes, I flip-flopped on the engine
choice once again; going for cubic inches rather than turbo-ing a 13B. The
RV-8 will have slightly longer wings than stock and if all works as I think
it will, it should give Bruce Bohannon a run ror his money in time to climb
competition. I commisioned Bruce Turrentine to build a new 20B from parts
using 13BREW front and rear end housings.
Anyone out there have the specific heat of gasoline at their fingertips?
BTW, I should have the prototype 6 pinion planet set soon. I will use this
on the 20B and would recommend anyone using a turbo 13B or 20B use it
instead of the stock Ford 4 planet. The RD-1(A) will be upgradeable to the
6 planet.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org