Subject: Top Dead Center position of 1986 13B
From: Paul
Date: 9/22/2000, 3:45 PM

Yvon Cournoyer wrote:

Good evening Paul,
In your article on Timing, you caution readers on rotating the engine to TDC
before e-shaft pulley removal.
I have been unable to find a description of TDC in the Mazda shop manual for
1986.
Where can I find a description of how to determine that the engine IS at top
dead center position?
Thank you.
Yvon Cournoyer

I don't recall saying that but here are ways of doing it.

One way is look in the exhaust port and when the apex seal just
passes the top of the exhaust port rotate the e-shaft about
another 90 degrees. Check your e-shaft pulley for marks when 
you do this. There should be a Top Dead Center mark on the pulley
but I am not sure about that. There usually is a pointer that sticks
out of the front cove. Also the keyway on the nose of the e-shaft
is opposite TDC on the front rotor. So when the keyway is in the
9 o-clock position the front rotor is Top Dead Center looking
at the front of the engine.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org