Subject: PRIVATE, PERSONAL .. not for list publication RE:'83 RX-7
From: Paul
Date: 9/23/2000, 10:17 PM

Dale Smith wrote:

It runs!  .... Wanted you to be the first to know!  I had
earlier traced the "no start" problem to the carburetor (old
news) ... but was a bit reluctant to tear into it as the
inside of a carb can be a real "can of worms" with dozens of
jets (which must be VERY accurately installed and
calibrated) etc.

However, the $350 price tag for a rebuilt one seemed
outrageous ... so "tear into it" I did!

Found a hairline crack in the top half of the carb body ...
actually just the cover for the float bowls, etc.  To make a
long story short, I applied a high temp, petro stable epoxy
(like JB weld ... but by permatex) to both sides of the
crack, filed the gasket bearing surface down (very
carefully) ... and bolted the whole mess back together with
a tightening sequence designed to flatten it back out.

Viola!  It fired right up immediately ... and runs
(understatement) ... VERY WELL!  Does not
idle too great yet, but runs like a scalded ape!  It just
seems to laugh at high RPM and begs for
more!  Very smooth.  I have not taken it much beyond 6000
(for now).  What power though!  For a 70 cu. in.
displacement engine ... it performs like a small block chevy
V-8!

It seems to have an almost neutral 50/50 balance of weight
distribution, and corners very, VERY well!  New tires will
only make this better than it already is ... which is great
now!

Third and 4th gears pull like a demon ... reving like a
banshee and getting stronger every second.

Hopefully, I can get many miles on my jury rigged fix.  Next
challange ... pass smog test, Oh joy!

Once again, thanks,
Dale Smith

Glad it is running.
Just to be on the safe side Dale mix one ounce of two cycle oil
in the gas tank to every gallon of gas. Been doing that on Robins
RX7. That way you won't have to worry about the oil injection pump
failing.

Paul