<< Yvon Cournoyer wrote:
>
> Good evening Paul,
> In your article on Timing, you caution readers on rotating the engine to
TDC
> before e-shaft pulley removal.
> I have been unable to find a description of TDC in the Mazda shop manual
for
> 1986.
> Where can I find a description of how to determine that the engine IS at
top
> dead center position?
> Thank you.
> Yvon Cournoyer >>
The best way is to use a regulated pressure source at about 30 psi in the
spark plug hole. Get the rotor close to tdc and turn on the pressure. Use
your hand on the flywheel to rotate the e-shaft back and forth slightly until
the balance point is found. If you get too far off just let go and it goes
purwhump about 90 deg...remove the air supply and reposition for another try.
Jeff Spitzer
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org