Al Gietzen wrote:

Looking for some help.  The injectors I want to use in the primary ports is
a Nippon-Denso that has a flow rating of 111-118 cc/15 sec.  Yup, apparently
that's how they rate them; translates to about 460 cc/min or 45 lb/hr.  This
apparently is one that was used by Mazda, but what I need is an
application - year, model; etc, - or a part number so I can figure out where
to get them.  I need the 12-15 ohm (saturated) version to use with Tracy's
EC2.  Local suppliers don't have any specs on these things.  Don't know if
there is an equivalent from another supplier.

In finding the MSD (Rochester) injectors for the secondaries, I found prices
ranging from $89 to $179 for the same injector from different sources.  Go
figure.

Al

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org