Every once and awhile I will go back and re-read a technical paper
in light of what I learn on the this newsletter.
One of the best papers around on these subjects is Design and Development
of the Voyager 200/300 Liquid Cooled aircraft Engine. SAE 871042
A few tidbits from this paper:
Water pump RPM 8100.
Pressure in cooling system 30 PSI.
Water flow rate 20 GPM.
Water temp into the block from the rad 250 F.
60%/40% EG/H2O.
Oil Temp into the engine from the cooler 250 F.
CD ignition system.
The 190 HP engine runs 200 degrees F lean of peak
at 2450 RPM and 26" Hg manifold pressure and generates 75 HP.
The fuel air ratio is .040 or 25 pounds of air for each pound
of fuel!!! This is 30 pounds of fuel per hour or 5 gallons
and hour at 75 HP.
The BSFC is 0.425. Up from 0.375 at 100 degrees F lean of peak
and 110 HP.
The six cylinder 190 HP engine weighs 304 pounds less coolant,
alternator, starter and exhaust manifold.
I am here to tell you a peripheral port, mass produced low cost Mazda
Mazda 13B rotary engine can easily compete with this engine except for
fuel burn. Not only that it will probably last longer.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org