Some comments to add to Paul's-
Taking the thing apart the positions do not matter, it is only when you are
building it up that you need to take care (unless you are doing on vehicle
maintenance, I suppose).
On my 91 13B the eccentric shaft pulley with the 2 index marks that line up
with the pointer on the front cover can only bolt on to the eccentric shaft
head bolt in ONE way. Pulley won't bolt up any other way. Yellow/white mark
on the pulley is 5 degrees ATDC for the leading plugs (there is a red mark
too, it is 20 degrees ATDC for trailing plugs) then rotate shaft pulley
yellow/white mark to front cover pointer and viola-you are close to TDC.
Don't know if the 86 is like this, although, but it is worth checking out.
And if you line up the white mark, the keyway is indeed at the 9:00 o'clock
position when viewed from the front of the engine.
The way you put the 91 distributor (crank angle sensor) in is to line the
white mark with the front cover pointer and then just put the distributor in
after lining up the dot on the distributor gear with the casting mark on the
distributor housing shaft. After this you can check timing with a light.
The is also the eccentric shaft keyway-
If you can't see the front keyway because you locktited and torqued in the
hub bolt, and you can still see the back keyway, then the back flywheel
keyway lines up with the front keyway (if memory serves me correctly).
True! PL
For
some reason the books talk about lining up the front keyway in the vertical
(top) position during disassembly, but I don't know why.
I believe I got all the above correct -age may be getting to me.
Marc Wiese 20B .....
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org