Some comments to add to Paul's-
Taking the thing apart the positions do not matter, it is only when you
are
building it up that you need to take care (unless you are doing on
vehicle
maintenance, I suppose).
On my 91 13B the eccentric shaft pulley with the 2 index marks that line
up
with the pointer on the front cover can only bolt on to the eccentric
shaft
head bolt in ONE way. Pulley won't bolt up any other way. Yellow/white
mark
on the pulley is 5 degrees ATDC for the leading plugs (there is a red
mark
too, it is 20 degrees ATDC for trailing plugs) then rotate shaft pulley
yellow/white mark to front cover pointer and viola-you are close to TDC.
Don't know if the 86 is like this, although, but it is worth checking
out.
And if you line up the white mark, the keyway is indeed at the 9:00
o'clock
position when viewed from the front of the engine.
The way you put the 91 distributor (crank angle sensor) in is to line
the
white mark with the front cover pointer and then just put the
distributor in
after lining up the dot on the distributor gear with the casting mark on
the
distributor housing shaft. After this you can check timing with a light.
The is also the eccentric shaft keyway-
If you can't see the front keyway because you locktited and torqued in
the
hub bolt, and you can still see the back keyway, then the back flywheel
keyway lines up with the front keyway (if memory serves me correctly).
True! PL
For
some reason the books talk about lining up the front keyway in the
vertical
(top) position during disassembly, but I don't know why.
I believe I got all the above correct -age may be getting to me.
Marc Wiese 20B .....
Yvon Cournoyer wrote:
Your comments and description of the eccentric shaft pulley and pulley boss
and distributor on your 91 13B are very much like those on my 86 13B.
Apparently identical. I say apparently because I do not wish to dismantle
my engine again this fall, to make and check the comparisons Without easy
visual access to the eshaft (front an/or rear) I have to rely on the front
pulley marks, which are exactly as you describe, However, I still have to
determine if my front pulley and pulley boss are 1986 vintage. (Age has
gotten to me)
Yvon Cournoyer--
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org