Subject: COrrosion protection: was- Fluid heat transfer properties
From: Paul
Date: 10/4/2000, 6:03 PM


   SNIP again

I think we are really agreeing about 97% here, with a slight
disagreement
on
semantics and "why", both of which are not worth much more effort.

Thanks for the good commentary.  Excellent points.

Bill


Actually we agree 100%.  I absolutely agree on the need for nucleate
boiling
at the hot spots.

There have been proponents on the list asking about other fluids (oils?)
that
had higher boiling points, apparently worrying about boilover.  These
heat
transfer oils, used for industrial processes requiring high temperatures
DON'T make good coolants for engines. Some numbers:

Water  k= 0.392  viscosity = 0.0123  Cp = 1.0  (best)
50/50 WG  0.260              0.0287       0.87 (next best)
glycol    0.135              0.086        0.64

Therminol 0.0753             0.1067       0.52 (Much worse, k= 1/5 that
of
water, viscosity = 8.5x water, and heat capacity ~1/2 that of water.

Clearly water is best but needs antifreeze because of low temperature
exposure, so some mix of water/glycol is what we use.

Bill

marc mularz wrote:

Hello all:
Well its been two weeks of the iron nail sitting in water/ glycol mixtures
and here are the results.
A.  The iron nail in pure distilled water (redundant) is severely corroded.
This began within SIX hours of being placed in the test tube !!!  As I
expected, its not the ions in the water that cause the corrosion, it's the
oxygen dissolved in the water.

B.  The nails placed in the water glycol mixtures show no corrosion that is
visible to the un-aided eye, even in as low as a 10 % solution.  I was
suprised that this low concentration of anti-freeze contained this degree of
anti-corrosive properties.

>From this, I would think that those who want to run a lower than 50/50 ratio
of water/glycol would only have to be concerned with the freezing and
boiling characteristics of their mixture.  OTOH I don't believe that a
difference of 0.12 in the specific heats of pure water vs. 50/50 is
significant in terms of the heat that must be removed by the cooling system.
  Hope this info helps.
Take care, Marc M

Good info.  I really appreciate your efforts to do this test.

Bill

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org